The process can be seen in our video entirely so as well as in detail, at the end of the instructions. Use the flathead screwdriver to remove the following 4 screws. Choose the far edge from the FFC cables or buttons.ĭo not use a lever or any force for separation that could damage the elements inside. With the tweezers detach the iPhone SE power and volume buttons ribbon cable. It is often most difficult to pass the tool between the parts to be divided. To facilitate the process, you can use isopropyl alcohol. Use a thin plastic film or pick for separation. The approximate heating temperature is 50° C / 125° F. ℹ️️ The surface of the display module must be heated to soften the adhesive underneath. You can use a home hairdryer, but you will have to make a nozzle by hand or have a suitable one in the kit to gently heat and concentrate the heat flow in the right place. We recommend using a special heating device such as a separator machine, heat gun, or heating mat. If you have no experience or are not sure of your skills, we strongly recommend that you contact a specialized service center. Lifting the display Put your iPhone SE on a soft, clean surface to avoid scratching the back. They are located to the right and left of the Lightning connector. Remove the two pentalobe screws at the bottom of the enclosure. ⚠️ Pay attention! Disassembly has a maximum 3rd difficulty because the process begins with the disassembly of the display module. You need a pentalobe screwdriver to open the iPhone SE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |